Open menu

Two-dimensional multibit optoelectronic memory

(Nanowerk News) Optoelectronic memories are devices which can store photon-generated charge carriers when exposed to light. The stored charges can be accessed later for information retrieval. These devices can be used in image capture and spectrum analysis systems.
2D atomically layered materials are promising candidates for the development of next generation optoelectronic memories to meet emerging requirements for device miniaturisation and structural flexibility.
However, optoelectronic memories fabricated using 2D materials have been reported to suffer from poor data storage capability with the highest reported figure at about eight distinct storage states.
A team lead by Prof CHEN Wei from both the Department of Chemistry and the Department of Physics, National University of Singapore (NUS) has developed a multibit, non-volatile optoelectronic memory device that is able to store up to 130 distinct states by using a tungsten diselenide/ boron nitride (WSe2/ BN) heterostructure (Nature Communications, "Two dimensional multibit optoelectronic memory with broadband spectrum distinction").
Schematic illustration of the optoelectronic memory device fabricated by layering a monolayer WSe2 on a 20-layer BN
Schematic illustration of the optoelectronic memory device fabricated by layering a monolayer WSe2 on a 20-layer BN. (Image: NUS)
The heterostructure, made of 2D materials, comprises a monolayer of WSe2 on a 20-layer BN. The programming (store data) and erasing (delete data) functions are controlled by adjusting the applied polarity to the device. A negative polarity is applied during the programming function and it causes the photon-generated electrons from the midgap donor-like states of the BN material to transfer into the WSe2 material.
This leaves behind localised (non-mobile) positive charges in the BN material. For the erasing function, a positive polarity is applied. This causes the photon-generated electrons from the valence band in the BN material to recombine with the localised positive charges, returning it to a neutral state.
The amount of electrons transferred into the WSe2 material is dependent on the duration of light exposure time for the device. A longer exposure time would mean that more electrons are transferred.
The researchers found that the continual accumulation of electrons in the WSe2 material corresponding up to 130 light pulses can be detected before saturation conditions set in. Each of these pulses can be treated as a distinct storage state.
During performance testing, they found that the device exhibits a data retention of over 4.5×104 seconds and a cyclic programme/ erase endurance exceeding 200 cycles.
Explaining the significance of the findings, Prof Chen said, “Although there is still a performance gap when compared to commercial silicon-based memory, these devices are advantageous in electronic applications which require structural flexibility.
The use of this WSe2/ BN 2D layered heterostructure provides a method to achieve multibit memory device and may pave the way for the development of next generation optoelectronic memories.”
Source: National University of Singapore
Subscribe to a free copy of one of our daily
Nanowerk Newsletter Email Digests
with a compilation of all of the day's news.
 
These articles might interest you as well: