Handheld surgical 'pen' prints human stem cells

(Nanowerk News) In a landmark proof-of-concept experiment, Australian researchers have used a handheld 3D printing pen to ‘draw’ human stem cells in freeform patterns with extremely high survival rates.
The device, developed out of collaboration between ARC Centre of Excellence for Electromaterials Science (ACES) researchers and orthopaedic surgeons at St Vincent's Hospital, Melbourne, is designed to allow surgeons to sculpt customised cartilage implants during surgery (Biofabrication, "Development of the Biopen: a handheld device for surgical printing of adipose stem cells at a chondral wound site").
Using a hydrogel bio-ink to carry and support living human stem cells, and a low powered light source to solidify the ink, the pen delivers a cell survival rate in excess of 97%.
biopen
Using the biopen.
3D bioprinters have the potential to revolutionise tissue engineering -they can be used to print cells, layer-by-layer, to build up artificial tissues for implantation.
But in some applications, such as cartilage repair, the exact geometry of an implant cannot be precisely known prior to surgery. This makes it extremely difficult to pre-prepare an artificial cartilage implant.
The Biopen special is held in the surgeon's hands, allowing the surgeon unprecedented control in treating defects by filling them with bespoke scaffolds.
Professor Peter Choong, Director of Orthopaedics at St Vincent's Hospital Melbourne, developed the concept with ACES Director Professor Gordon Wallace.
"The development of this type of technology is only possible with interactions between scientists and clinicians - clinicians to identify the problem and scientists to develop a solution," Professor Choong said.
The team designed the BioPen with the practical constraints of surgery in mind and fabricated it using 3D printed medical grade plastic and titanium. The device is small, lightweight, ergonomic and sterilisable. A low powered light source is fixed to the device and solidifies the inks during dispensing.
"The biopen project highlights both the challenges and exciting opportunities in multidisciplinary research. When we get it right we can make extraordinary progress at a rapid rate," Professor Wallace said.
Source: ARC Centre of Excellence for Electromaterials Science